Vegetation encroachment detection for rail corridors

We find vegetation that encroaches on fence lines, clear zones and overhead wiring using drone LiDAR. Each item gets an ID, measurements, photos and cut heights your tree crews can work from.

What we check

Every corridor is set up with the assets and zones that matter to your network, then the point cloud is checked against them.

  • Fence clear zones. Boundary, intrusion (UTO), segregation and overbridge fences, each with its own clear-zone width.
  • Track danger zones. Vegetation within the zone either side of the track.
  • Overhead wiring. Zones centred on each stanchion, so growth near the wiring is caught.
  • Line-of-sight clearance. Vegetation obstructing existing trackside equipment, such as signals and cameras, is listed as clearance work.
  • Protected habitat. Areas where trimming is restricted are marked, so crews know before they arrive.
  • Land ownership. All land is checked. NSW Cadastre boundaries show where trimming needs a neighbour's permission.

How each item is measured

Cross-section of a rail fence and an encroaching tree The gap is measured horizontally from the fence face to the nearest vegetation point. Vegetation inside the clear zone, or above the height limit, is listed with a trim line. Gap Height limit Clear zone Track Fence Trim line
The gap is measured horizontally from the fence face to the nearest vegetation point. The shaded part of the tree is inside the clear zone and is listed for trimming.
  • Horizontal gap: from the fence face to the nearest vegetation point in the point cloud.
  • Height limit: fence top plus an allowance you set.
  • Cut heights: for growth overhanging the fence, measured from the fence top; outside the fence, measured from the ground.
  • Split items: a tree that straddles two overhead wiring zones is listed once in each zone, with a "continues in" note so crews see the whole job.

Clear-zone widths and allowances are set to your network's standards before the check is run. Each item can also be given its own clearance, for example where a wider cut is needed away from the fence.

What you get

Deliverables your crews and planners can use

  • PDF reportA4 report with a summary and item pages grouped by zone.
  • Trim sheetsOne sheet per item for tree crews: location, photos, cut heights and a simple 3D drawing of the cut.
  • CSV item listEvery item with its ID, zone, measurements and status, ready for your asset or work-order system.
  • KML / KMZItems and zones to open in Google Earth or GIS for planning access.
Questions

Common questions

Is this a survey?

No. We provide spatial data capture and observations for review. Measurements come from the point cloud, with the coordinate system and correction method stated, and decisions on trimming stay with your team.

How long a section can you cover?

We capture and check corridors in workable sections, matched to how your crews will act on them. Tell us the length and locations and we'll suggest how to split it.

How do you handle access and safety?

We agree access and safety arrangements with you before any flight, including where we fly from and any rules for your corridor. Flights follow CASA rules.

Can the same item be found again on a later visit?

Yes. Item IDs are based on the zone, so crews and planners can match the same tree or patch of growth between visits.

Does this work for power lines or other linear assets?

The same approach applies to any asset with a clearance rule. Talk to us about your clearance standards and we'll tell you what we can check.

Have a corridor with vegetation to check?

Tell us the location, length and clearance rules. We'll come back with a scope and a price.